Tuesday, November 17, 2026

The Pleiades K117 220R 910K JFET microphone booster amplifier for connecting Shure SM7 and other dynamic microphone to mobile phones etc prototype is ready

 

At your risk.


It is to be connected to any electret mic input and the K117 JFET gets power supply from there in the usual way.


A step up microphone input step up transformer is to be connected between dynamic, ribbon or self powered condenser microphone and the Pleiades K117 pre preamplifier. Please see older posts for schematic.


The schematic is possibly the simplest possible with just 2 resistors and 1 JFET. The model number is really how it is made. A K117 JFET a 220ohm resistor connected at the source terminal for suitable voltage bias, a 910Kohm resistor connected between gate and ground.


Everything is built inside a Neutrik NC3FX (female 3 pole XLR connector).


The preamplifier is so low noise and high gain making a low output microphone fully modulate the VU meter of GarageBand on a more than 10 years old iPad mini. Even for a soft voice at 24in.


Signal path:


Sennheiser MD421HN used at low Z at 24in form singer 30 degrees above head towards nose - 1:10 German step up transformer inside XLR barrel - Pleiades K117 220R 910K - mic terminal of headphone mic splitter cable to 4 terminal 3.5mm - Apple iPad mini


It is nice that part numbers can contain information in a code.


For example on Neutrik NC3FX, 3 should mean 3 pole, F for female etc.


Or foe example the electron tube ECC83, E meaning 6.3V at heaters, C triode, C another triode etc.


The first stage noise performance dictates the noise performance of the whole system up to the  listener's mind. If there is hiss in the first amplifiers it will be further multiplied by next stages. So the less noise in the first stage the better for the whole system.


On the Neutrik female connector the shield terminal can be connected to pin 1 (external) for less noise pickup and stability.




No comments:

Post a Comment