It would be great to make a Pleiades microphone pre preamplifier as follows:
Everything inside Neutrik XLR modules:
Inside a Magnetec 073 nanocrystalinne core, few primary turns for bass proximity compensation.
Capacitor coupling of secondary to a K177 JFET.
Everything inside the Neutrik modules and power and drain resistor supplied by the iPad headphone mic connector.
This would provide at the same time: proximity compensation for next to mouth mic work, make up gain, extremely low noise, ie great signal to noise ratio, portability, crystal clear sound.
Everything inside Neutrik XLR modules:
Inside a Magnetec 073 nanocrystalinne core, few primary turns for bass proximity compensation.
Capacitor coupling of secondary to a K177 JFET.
Everything inside the Neutrik modules and power and drain resistor supplied by the iPad headphone mic connector.
This would provide at the same time: proximity compensation for next to mouth mic work, make up gain, extremely low noise, ie great signal to noise ratio, portability, crystal clear sound.
No comments:
Post a Comment