At your own risk. All safety precautions should be followed when working with a voltage even a low one.
The 6080 has a very low μ of 2. According to a rule of thumb [Atkins] it should operate with a very low plate voltage.
Would it produce a very low output impedance with a 12V plate supply and pull up or Pleiades bias?
If it is directly connected to plate instead of a load resistor...
Problem is that the heater consumption is excessive. Underheating may produce better sound results or not since now power is requirement not low noise.
References:
https://frank.pocnet.net/sheets/173/6/6080.pdf
http://www.rfcafe.com/references/radio-news/low-plate-potential-tubes-january-1957-radio-television-news.htm
No comments:
Post a Comment